stark1261

Hey Ordo! Long time no post! Here is our current set of trenches and bunkers progress! Our first release of printable files can be picked up at MyMiniFactory.com under campaigns. Search by Hexhog. This set coming to KS in next 3 months.

Ok team Ordo! It has been a lot of fun to share as this project has moved along. It will soon be time for this project to leave the safety of its lair in my garage and venture out into the world. We are planning a Kickstarter tentative for early July. (3d printable files) picture below is the summer theme on a hexagon skirmish table. here is a link to a video post I made over on reddit. Flyover video link we also have a webpage now, nothing fancy but it exists! www.hexhogtabletops.com Thanks for all the likes, comments and feedback!

Progress shots of 4’x4’ winter table

Time for an update! Spring version of Area hill: Here is a gif of 24”x24 time lapse encounter table winter themed. https://i.imgur.com/DSDAzL1.gifv Getting ready for a digital Kickstarter! Going to have 5 levels. Send me a PM of your email if you want to be notified when it goes alive.

Some day that may happen. Right now looking to do some detailed sculpting of taller hexes. i think I want to do a roadway after that and then see where it goes... Video Link on Reddit: Video Link

Some day that may happen. Right now looking to do some detailed sculpting of taller hexes. i think I want to do a roadway after that and then see where it goes...

Working on increasing table size. When finished will be 48”x48”. Also updated all hex models with revised digital sculpting.

Updates:

Update time! Working on the table side of the project about 4” of elevation change from one long side to the other! Didn’t realize how many of my new pieces I would need so printing to fill blank spots. Here is a gif of the area terrain option with same pieces. https://i.imgur.com/ZoUlt8F.gifv

Yes, already done. The system uses openLOCK, those are integrated into the base and frame pieces only though, to support modularity there are several pieces without openLOCK, such as all the ones with details. And below is FDM print results at .15mm looks good in my opinion. Going see if I can source a cheap print on a resin printer.

Hired a sculptor to do details (way way faster than me) on a single piece as I have had a couple people ask about kickstarting the idea, which I would want more detail. I already bought a waymo sculpting pen for myself and started to play around, will take me a while so that is the fallback plan if this is too much detail. Printer is running right now so will see tomorrow if prints have details are noticeable at .15mm later height in the new version. Here are digitals, left is original, right is extra detail in the slicer. If I had a resin printer I am pretty certain I would notice!

Update: I received some good feedback I was able to integrate for the area terrain edges option. Files coming off the printer are pretty solid and make a more aesthetic piece of terrain. New is on the left, though unpainted. Definitely will look better plopped on the table.

Update! Painted but not yet sealed. Thinking will break in this weekend with kids fighting a bunch of Skellie’s on DND adventure we have going.

Height goes up, that was the key to the idea. I already have some prototypes that step up two standard hex heights per hex the immediately pictured above all step up one. I designed an internal “frame” hex that is hollow that supports and stacks up or laterally in a nice lattice. i have been working on some model pieces to allow me to set on edge at say 7 inches and then the other side will fall to the 1/2” most of the table above is. the picture below has a two level hill on the left, the little out crop sits on top of four frames, the outcropping on the right back has a single hex at the second level.(in progress to paint all the silver pieces)